Problem with acceleration.

Hi all!

This weeks challenge was a tough one! It took me a while to figure out what I was doing. The code was uploading fine once my computer found “Leonardo” 😛

However, it seemed that no amount of shaking was going to light up any LED’s on this cardboard. My stitched weren’t the best or tightest however I knew that the connection was strong from last class.  It wasn’t until I spoke to some of my classes that I realized the “Thresh-hold” was set too high and that if I dropped it down to a low number it would make the sensor very sensitive.  Below are photos and videos of the LED lighting up! 😀 Finally!

Screen Shot 2013-09-22 at 10.02.05 PM

IMG_2489

IMG_2490These are some ugly stitches 😀