Kodak Pocket Video Camera Teardown

 

 

1k1a0968

 

20160914_151532

 

20160914_151607

PCB had HDMI connector, A/V outlet, DC IN 5V for charging.

20160914_151258

 

20160914_151249

 

The product has a very complicated assembly consisting of:componants-01

20160914_151219_1

 

The Kodak Zx1 was a Pocket Video Camera released in 2009. Its logic board carries multiple chips on PCB:

  • AAT1415 – Advanced Analog Technology (FIVE-CHANNEL DC-DC CONVERTER WITH A 2.5V LDO)
  • Hynix – HY27SF081G2A-FPCB, Part Category: Memory ICs, Manufacturer: SK Hynix, Description: 128MX8 FLASH 1.8V PROM, 30ns, PBGA63
  • Ambarella (A2S30 A2S-A1-RH) – Product Category: IC Chips, Manufacturer: Ambarella, Description: A2S30 A2S-A1-RH Datashee, Package: BGA, Quantity: 609 PCS, Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Moisture Sensitivity Level(MSL): 3(168 Hours
  • Hynix (HY5PS1G1631CFR) – 1Gb DDR2 SDRAM – SK hynix
  • WM  
  • WM8978GEFL/RV Cirrus Logic Audio CODECs STR CODEC w/HP SPKR 32-pin (Sep 2016) Mouser Electronics (Recorder)
  • WM8978GEFL/V Cirrus Logic Audio CODECs Stereo Codec with H/P Spkr (Sep 2016) Mouser Electronics (Speaker)

 

Untitled-2.jpg

 

The Tools that I used to take it apart:

  • Small cross head screw driver
  • Leatherman multitool

 

Apparently, I picked a quite delicately made object. At the first glance, this pocket camera seemed very simple and easy to tear down. I was totally wrong about that and took me quite long time to understand each part. I used simple techniques of delicately unscrewing many cross head screws, and there were many of them even inside of the camera to hold its PCB. I also used multitool to open up its case and detaching the LED monitor screen from the aluminum board. I found that there are yellow plastic cover  between monitor screen and PCB, and it was there for protecting processor chips. I was also very amazed by the size of camera that were placed on the PCB. Perhaps, I should use this camera component for Arduino later.

The size of this pocket camera was just about the size of cigarette case, but it had rounded corner.  I also found that the plastic extorior was coated with rubber material. The designer of the camera must have designed it this way for users to have a better grip, and I like the way it was.

One thought on “Kodak Pocket Video Camera Teardown

  1. Becky Stern

    Fun device choice! Your teardown could use a bit of beefing up, however. Please refer to the assignment post and add the following:

    Identify the materials used for each component

    Identify the manufacturing techniques/equipment used to make it

    Look up part numbers on chips and find out what they do (searching the part number + “datasheet” helps)

    Make a list of the tools and techniques you used to take it apart

    Select two design elements that interest you and describe why you think the designer made it that way

Comments are closed.